Yamaha A-S501 Integrated Amplifier (Black)

Expand your listening horizons with the black A-S501 Integrated Amplifier from Yamaha Featuring up to 100W per channel of RMS power at 6 ohms - this amp is equipped with digital inputs for connecting devices like televisions and Blu-ray/DVD players It offers dual stereo outputs - giving you the ability to power two sets of speakers in different rooms and switch between them - or have them both playing at the same time To increase the bass output of your sound system - there's also a terminal for connecting a subwoofer To reduce distortion and degradation and produce the cleanest possible sound - the A-S501 employs Pure Direct Mode Activated via a button on the front of the unit - this mode causes input signals to bypass unused circuits and cuts off those circuits' power supply To further ensure quality sound - the amplifier's continuously variable loudness control allows you to balance low and high frequency sounds so you can hear a full tonal range at any volume This Yamaha amplifier was built with energy efficiency in mind - and uses a power management system to switch itself to idle mode when not in use The A-S501's internal circuitry mirrors itself symmetrically to produce higher signal purity and lower degradation The chassis is reinforced with a solid center bar to reduce vibration and features a brushed aluminum front panel and knobs The system comes with a remote control for easy operation

Features: Brushed Aluminum Front Panel, Symmetrical Layout, Reinforced Chassis, Power Management (Auto Power Off), Pure Direct Mode, Subwoofer Out, Speaker A, B or A+B Selection, Optical and Coaxial Inputs, 100W x 2 (6 Ohm RMS) Power Output, Continuously Variable Loudness Control

Amplifier Type: Integrated Amplifier (Preamp/Power Amp Combo)

Channels: 2.0

Power Output per Channel: 100 W at 6 Ohms / 20 Hz to 20 kHz / 0.038% THD (RMS) 85 W at 8 Ohms / 20 Hz to 20 kHz / 0.019% THD (RMS)

Dynamic Power per Channel: 130 W at 8 Ohms150 W at 6 Ohms185 W at 4 Ohms220 W at 2 Ohms

Frequency Response: 20 Hz to 20 kHz ±0.5 dB (Pure Direct Mode)10 Hz to 100 kHz ±1 dB

Residual Output Noise: 40 µV (IHF-A)

Tone Control: Bass (20 Hz): ±10.0 dBTreble (20 kHz): ±10.0 dB

Damping Factor: ≥ 240 (8 Ohms - 1 kHz)

Supported File Formats: PCM

Supported Sample Rates: Up to 192 kHz (PCM)

DAC: 192 kHz / 24-Bit

Rear A/V Inputs: 5x Stereo RCA1x Stereo RCA (Phono) with Ground Screw1x Optical TOSLINK1x Digital Coaxial

Rear A/V Outputs: 2x Stereo RCA1x RCA Subwoofer

Front I/O: 1x 1/4-inch / 6.35 mm Headphone Output

Other Rear I/O: 1x USB-A (Power)

Speaker I/O: 4x Binding Post Pair4x Binding Post Pair

Input Impedance: Phono (MM): 47 Kilohms Line: 47 Kilohms

Input Sensitivity: Phono (MM): 3 mVLine: 200 mV

Max Input Level: Phono (MM): ≥ 45 mV (1 kHz / 0.03% THD)Line: ≥ 2.2 V (1 kHz / 0.03% THD)

Phono RIAA EQ Deviation: ±0.5 dB

Rated Output / Impedance: Headphone: 430 mV / 470 OhmsLine: 200 mV / 1 KilohmsSubwoofer: 3.5 V / 1.2 Kilohms

Signal to Noise Ratio: Phono (MM): ≥ 82 dB (Input Shorted)Line: ≥ 99 dB (Input Shorted / Direct Mode)

Total Harmonic Distortion (THD): Phono (MM) to Line Out: ≤ 0.03% (20 Hz to 20 kHz / 2.5 V Input)Line to Speaker Out: ≤ 0.019% (20 Hz to 20 kHz / 45 W Output / 8 Ohms)

Channel Separation: Line - Phono - RCA:≥ 65 dB (5.1-Kilohm Input Shorted / 1 kHz) ≥ 50 dB (5.1-Kilohm Input Shorted / 10 kHz)

Wi-Fi: No

Bluetooth: No

AC Input Power: 120 VAC - 60 Hz

Power Consumption: Active: 240 WMaximum: 510 WStandby: 0.5 W

Dimensions (W x H x D): 17.1 x 5.9 x 15.2-inch / 43.5 x 15.1 x 38.7 cm

Weight: 22.7 lb / 10.3 kg